Riso 7010R Manual do Utilizador descarregar pdf (Página 2)

2

11. Remov e two Fi xed Shaf ts f rom the

Belt Platen Unit at A as shown in the

illustration.

12. Secure the Fixed Shaft at B of the

Frame. (IT M4x8 2pcs.)

Note :

- Reuse the screws removed at the

procedure 9.

- Fit the rear side of the Fixed Sha to

meet the D hole on the rear frame.

13. Secure the ground wire to the Belt

Platen Unit. (IT3C round top 4x8 1pc.)

Important :

Attach the connector of the ground

wire from the left, and lead the ground

wire as shown in the illustration.

Note :

Reuse the screws removed at the

procedure 9.

Belt Platen Unit

Fixed Sha

Ground wire

A

A

B

B

6. Remove the Inner Cover. (7 screws)

Note :

Remove the Inner Cover by pulling out

the Horizontal Transfer Unit.

7. Remove the screws 1 on the lower part

of the Bracket of the Belt Platen Unit.

(2 screws)

Important :

Do not remove the screw A.

8. Push the Bracket.

9. Remove the screws 2 on the upper part

of the Bracket. (4 screws)

Note :

Three screws out of six screws will be

reused at the procedure 12-13.

10. Remove the Bracket.

Horizontal Transfer Unit

Inner Cover

Ａ

2

1

Bracket

7

42. Set the Ink Cartridges.

Important :

- Remove the bottle caps  rst before

setting the Ink Cartridges.

- Place each color of the Ink Cartridge

to the indicated places.

43. Remove the screws of the Cartridge

Holder. (2 screws)

(K) (C) (M) (Y)

Cartridge Holder

Cartridge Holder

Stay

Screw

44. Stand the Cartridge Holder and keep it

with the stay.

Important :

Be sure to secure the stay with a screw

to prevent falling down.

45. Close the Front Cover.

46. Plug in the Power Cord.

47. Turn on the printer and input required

information on the introduction wizard.

Note :

INK INITIALIZATION begins. (about

5 minutes)

48. Start up the test mode, and enter [2452]

(INK CIRC ACTION), then press the

Start key.

Note :

 e test mode is  nished automatically

after having worked for about 10

minutes.

49. Enter [726] and set the value to [1], and

then press the Start key.

50. Turn o the printer.

51 . Open the Front Cover and replace the

Cartridge Holder. (2 screws)

1 2 3 4

Comentários a estes Manuais

Sem comentários